ChimneyRx Paint n Peel Fireplace Cleaner 1/2 Gallon
Have
a smoke and soot stained fireplace? ChimneyRx Paint “N” Peel Fireplace
Cleaner is your answer. Over time small black carbon-based particles
embed into your masonry surface around your fireplace. These stains are
very difficult to remove and usually require the use of harsh chemicals
in your home with a lot of time and mess until now… With ChimneyRx
Paint “N” Peel Fireplace Cleaner your fireplace can look new again. The
cleaner is specially formulated to remove smoke and soot stains. It's as
easy as 1,2,3. Paint on,Let it Dry, Peel it off.
Chimney RX Paint
“N” Peel Fireplace Cleaner is a water- based cleaning poultice that
removes unsightly smoke, soot, creosote and dirt stains from masonry
fireplace fronts and hearths. No additional water is needed for
application or removal. Simply paint the product on the surface, allow
it to dry, and then peel it off.
Coverage:
When
applied at 1/8”-3/16” thickness, product will cover 20 - 40 sq. ft. per
half gallon depending on the texture and density of the surface.
DIRECTIONS FOR USE
Do not thin product. Apply when surface and air temperatures are between 45°F and 95°F.
Preparation:
Wipe
surface with a dry or slighty damp rag to remove dust. Mask off work
areas and cover all non-target surfaces with plastic or dropcloths. The
use of removable painters tape is recommended to protect surfaces
adjacent to product application, such as fireplace glass doors,
fireplace mantles and any trim that abuts the masonry to which product
is to be applied. Be sure to protect all surrounding carpet, fabric,
metal, wood, and painted surfaces from inadvertent spills and roller
splatter, as product may cause stains or damage to non-target surfaces.
For best results, surfaces to which product is to be applied should be
dust free, dry, and cool to touch before application. Do not apply while
fireplace is in use.
APPLICATION
Stir before
use. Apply a thick, liberal coat, approximately 1/8” – 3/16” thickness
using a paint brush and/or a thick nap roller. Be sure to maintain the
recommended thickness across the entire surface area to be coated and
near the edges of your project. Ensuring an even application will help
the product peel off easily and uniformly when dry. For areas that are
more heavily soiled, agitation with a stiff nylon bristle scrub brush
may be required to help the product work deeper into the surface. Once
surface has been agitated, recoat to be sure a thick, even application
of product remains on surface. On extremely porous surfaces or in
extremely dry conditions, it may be beneficial to lightly mist the
surface with water, agitate with a soft bristle brush and blot dry with
clean rags just prior to application to help prevent product from drying
out too quickly
