MasonrySaver Brick Water Repellent is a penetrating, V.O.C. compliant, water repellent which contains a proprietary modified siloxane. This water-based siloxane penetrates masonry up to 1/4 inch or more depending on surface porosity and moisture content at the time of application.

MasonrySaver Brick Water Repellent reacts with the minerals in masonry in the presence of ultraviolet light and atmospheric moisture. This reaction forms strong permanent bonds beneath the surface and creates a hydrophobic zone that prevents water molecules from penetrating, while allowing free migration of water vapors. The chemical bonds formed in this process allow MasonrySaver Brick Water Repellent to become an integral part of the substrate and provide long-term water repellent protection.

• MasonrySaver Brick Water Repellent protects most vertical and horizontal exterior, above-grade masonry surfaces including: adobe, architectural concrete (precast or cast-in-place), clay brick, mortars, natural stone, limestone, granite, sandstone, terra cotta, exposed aggregate products, Portland cement stuccos and concrete masonry units.
• Natural substrate color and surface textures are unaffected, with little or no gloss created. Slight darkening may occur on dense surfaces.

Available Sizes: 1, 5, 30 & 55 Gallon Containers
Coverage Rate: (Sq. Ft. per Gallon)
Brick: 100-150
Block: 50-75
Concrete: 75-150
Stucco: 75-150
Limestone: 75-150
Application Temperatures: Minimum 40 degrees F
Dry Time: 1 - 2 hours (allow 6 hours before rainfall)
Application Method: Low-pressure Sprayer
Cleanup: Soap and water